学术报告
  网站公告
  友情链接
·大连理工大学
·大连理工大学运载工程与力学
·大连理工大学工业装备结构分
·中华人民共和国科学技术部
·教育部
·大连理工大学人事处
·计算力学学报
更多>>  
当前位置: 首页>>学术活动>>学术报告>>正文
 
学术报告——Carbon-fiber aluminum-foam sandwich with short aramid-fiber interfacial toughening
2012-04-10 来源:大连理工大学工程力学系    (点击: )

报告人:胡晓智教授

Winthrop Professor
School of Mechanical and Chemical Engineering,The University of Western Australia
报告时间:2012年4月19日上午8:30

报告地点:综合实验1号楼602

主办单位:工业装备结构分析国家重点实验室,土木工程学院



Carbon-fiber aluminum-foam sandwich

with short aramid-fiber interfacial toughening


     Interfacial toughness and toughening mechanisms of a sandwich beam, consisting of an aluminum foam core covered with two carbon-fiber/epoxy composite face sheets, are investigated in this study. Short aramid fibers of different lengths and densities have been inserted at the interface during the sandwich fabrication process, to improve the interfacial toughness of the sandwich beam.

The results indicate that the average critical energy release rate GCof the carbon-fiber aluminum-foam sandwich samples with the aramid fibers increases by about 100%than the non-toughened samples. Improvements of varying degrees in the interfacial toughness were observed for all specimens toughened with short aramid fibers of different lengths.

The interfacial toughening performance and underlying mechanisms for energy absorption were discussed and analyzed using scanning electron microscopy. For the sandwich samples fabricated in this study, short aramid fiber, are more effective than longer aramid fibersas free aramid fiber ends from those short aramid fibers can more effectively utilize surface cavities of the rough-surface aluminum foam, thus leading to more effective fiber-bridging and higher interfacial toughness.

 

Porous hydroxyapatite coating on strong ceramic substrate fabricated by lowdensity slip coating-deposition and coating-substrate co-sintering

    This study aims at developing a process technique, which can deposit porous scaffold-like hydroxyapatite (HA) coatings on strong ceramic substrates. As a first trial, micro-porous HA coatings on strong zirconia-based substrates are fabricated by the following technique—consisting of low-density HA-slip coating-deposition on the micro-porous substrates pre-sintered at 900◦C, and coating-substrate co-sintering at 1300◦C. The final co-sintering process ensures a strong bonding between the HA coating and the zirconia-based substrate after minimizing the mismatch in thermal expansion coefficients by adding alumina in HA coating and HA in zirconia-based substrate. The presence of porosity in the HA coating also reduces the mismatch. HA decomposition during the co-sintering process is discussed.

关闭窗口
   
 
地址:中国·辽宁省大连市甘井子区凌工路2号 大连理工大学  邮编:116023  电话:0411-84708390
版权所有:大连理工大学工程力学系  Copyright © 2010 All rights reserved.  
技术支持:大连理工大学N维网